Speed & Proximity Sensors
Geartooth Speed and Direction Sensor
|
Features |
SD1012 |
|
|
|
|
|
Hall-effect geartooth speed and direction sensor
with flange-mount plastic housing.
- Sense speed and direction of ferrous geartooth targets
- Plastic flange mount sensor rated to 125°C
- Near zero speed sensing capability
- Locating mark provided to ensure correct rotational alignment
- 10-bit dynamic threshold detection offers:
- Automatically adjusting magnetic range
- Self-compensating to target geometry
- Immune to target run out
- Reverse battery protected to -30VDC
- Internal circuit protection to IEC529 1000
- EMI resistant to 10V/m, 30MHz to 1GHz
- ESD resistant to 4kV (Contact discharge)
- Electrical fast transient resistant to 2kV
- Conducted immunity resistant to 10VRMS@150kHz to 80MHz
- EMC compatible 30A/m @ 50 Hz
- Designed to meet IEC529 IP67 for dust and water protection
- Integral Connector version: 4-pin Delphi Metri Pack 150.2 No. 12162833. Mates with Terminal No. 12124075.
applications
- Wheel speed and direction
- Transmission speed and direction
- Hoist speed and direction
|
|
| |
| Part # |
Operating Voltage Range (VDC) |
Supply Current (mA max.) |
Output |
Output Saturation Voltage
(mV max.) |
Output Current (mA max.) |
Operating Temp. Range
(°C) |
Storage Temp. Range
(°C) |
Housing
Material |
| SD101201 |
4.75 to 24 |
20 |
sink |
1000 |
20 |
-40 to 125 |
-40 to
125 |
Plastic |
Notes:
SD101201 uses Delphi Metri-Pack 150.2
Series Part No. 12162833.
Mating terminal: Delphi Part No. 12124075.
A pull up resistor is required between
power and each output.
Resistor value is dependent upon input
voltage.
|
|
|
| Open Collector
Sinking Block Diagram |
|
 |
| |
Inches (mm)
All tolerances ±0.005 (0.13) unless otherwise
noted.
|
 |
|
Click on image to enlarge.
|
Specifications subject to change without notice.
|
